Dromida Nylon Insert Steel Lock Nuts 3mm (6)

These are the 3mm Locknuts for the Dromida SC, MT and BX Vehicles.

FEATURES:
Steel construction, with nylon insert

INCLUDES:
6 3mm Locknuts

Want an additional terrific item to match the above stated item?

Suspension Arm Lower BX MT SC 4.18 (2)

These are the Lower Suspension Arms for the Dromida SC, MT and BX Vehicles.

FEATURES:
Plastic construction
Fits front or rear suspension

INCLUDES:
Two Lower Suspension Arms

You will love this product if you have the product earlier pointed out.

Wheel Axle Set BX MT SC 4.18 (4)

This is the Wheel Axle Set for the Dromida SC, MT and BX Vehicles.

FEATURES:
Plastic construction

INCLUDES:
Four Axles
Four 2.5mm O-Rings

This item praises the main item below.

Drive Shaft Spacer Set BX MT SC 4.18

This is the Drive Shaft Spacer Set
for the Dromida SC4.18, MT4.18 and BX4.18 Vehicles.

FEATURES:
Installs on either side of assembled differential

INCLUDES:
Four O-Rings
    Four Springs, key #35

Numerous others have purchased this item together with the item that you are presently reviewing.

Body Clip BX MT SC 4.18 (10)

These are the Body Clips for the Dromida SC, MT and BX Vehicles.

FEATURES:
Steel construction

INCLUDES:
Ten Body Clips

Get this item to improve the one you are reading around.

Hinge Pin 2x36.5mm BX MT SC 4.18 (4)

These are the 2x36.5mm Hinge Pins for the Dromida SC, MT and BX Vehicles.

FEATURES:
Metal construction
Fastens A-Arms to chassis

INCLUDES:
Two Front and 2 Rear Inner Hinge Pins

This is a superb enhancement to the item presently being gone over.

Hinge Pin Holder Set BX MT SC 4.18 (2)

This is the Hinge Pin Holder Set for the Dromida BX, MT, and SC Vehicles.

FEATURES:
Plastic construction with steel pins
Fits front and rear drive systems

INCLUDES:
One Front and one Back Hinge Pin Holder
Two 2x14mm Flat Head Screws
Two 2x10mm Flat head Screws

This item praises the main item below.



This is the Servo Saver Set for the Dromida SC, MT and BX Vehicles.

FEATURES:
Metal and plastic construction
Helps to prevent damage to the servo in the event of a front end
    crash

INCLUDES:
Spline, Arm, Spring, and Cap
One 2x10mm Round Head Device Screw
One 2.6x5mm Washer