Castle Creations Sidewinder 3 Waterproof 1:10Th 12V Sport Car Esc

This is the Castle Creations Sidewinder SV3 12V Electronic Speed Control.

FEATURES:
Recommended for all 1/10 scale buggy and truggy applications that
    weigh less than 5lbs (2.25kg) ready to run (not for use in heavier
    cars such as E-Revos or E-Maxx class cars)
USB programming capability by means of Castle Link USB adapter (not included,
    order CSEM6300)
Water resistant for use in nearly every environment (not meant for
    operation while submerged in liquid)
Suitable with the Castle Creations 14xx series NeuCastle motors
Reversible with reverse lockout

CONSISTS OF:
Sidewinder SV3 12V ESC with 13 gauge Battery Wires with Pre-Tinned
    Leads, 4mm Female Bullets for Motor Connection, Receiver Port
    On/Off Change, and Instructions

REQUIRES:
Battery adapters

SPECS:
Input Voltage: TWO LiPo minimum, THREE LiPo optimum, 9 cell NiCd/NiMH
Brake: Proportional
Reversible: Yes, with lockout
Dimensions: 1.93 x 1.48 x 0.79" (49 x 38 x 20mm)
Weight: 1.96 oz (55.5 g) with 5" (127mm) long battery wires and no
    battery connector

Below is a fantastic product that several others have actually purchased the very same time.

Push Rod Assmbld W/Rod Ends (2) For Use W/#5359 Revo

These are the (optional) Steel Pushrods for the Rocker Arms
for the REVO from Traxxas
These go in between the Rocker Arms and the Lower Suspension Arms

FUNCTIONS:
Black steel construction

CONSISTS OF:
Two Pushrods w/pre-installed rod ends and balls

REQUIRES:
Setting up on the vehicle

SPECS:
Length: 5.4" (137mm) end to end consisting of rod ends
Diameter: 0.20" (5mm)

COMMENTS:
For rod ends just use TRAC5347

This product praises the above talked about product.

Castle Bec 10Amp (25 Volt Max Input)

This is the CC BEC 10A Receiver Battery Eliminator by Castle Creations.

FEATURES:
Gets rid of the need for a receiver and servo battery pack
Draws greater voltage from the motor batteries and drops it to a
    voltage level appropriate for the receiver and servos

CONSISTS OF:
One CC BEC receiver battery eliminator

REQUIRES:
Setup in the airplane

SPECS:
Length: 1.2" (30mm)
Width: .6" (15mm)
Height: .4" (10mm)
Weight: .4oz (11g)
Input voltage: 5V to 25.2V (TWO to SIX LiPo)
Existing output: 12 volts input = 7 amps* continuous, 10 amp peak;
    24 volts input = 5 amps* continuous, 7 amp peak
    *Ratings are figured out with a 5mph airflow on the BEC
Selectable Output: 4.8 - 9.0V by means of the Castle Link (offered separately)
    Default voltage is 5.1V

This product praises the above talked about product.

Rock Crawler Brushed Motor 35T HD

This is the Tekin T35 HD 35 Turn Rock Spider Brushed Motor.

FEATURES:
High-strength updated ferrite magnets
Legal for rock crawling competitors
Completely rebuildable
Dual precision ball bearings
120 day limited service warranty

CONSISTS OF:
Tekin T35 HD 35 Turn Rock Spider Brushed Motor

REQUIRES:
ESC such as the Tekin FXR Brushed ESC, TEKM1091
Motor leads
Pinion gear depending upon vehicle

SPECS:
Input Voltage: THREE LiPo or 10-cell NiMH battery
Dimensions: 2.07 x 1.42" (52.7 x 36mm)
Shaft Diameter: 0.125" (3.2mm)
Bearing Size: 3/8 x 1/8"
Motor Weight: 5.98oz (169g)