Castle Creations Sidewinder 3 Waterproof 1:10Th 12V Sport Car Esc

This is the Castle Creations Sidewinder SV3 12V Electronic Speed Control.

FEATURES:
Advised for all 1/10 scale buggy and truggy applications that
    weigh less than 5lbs (2.25kg) all set to run (not for usage in much heavier
    automobiles such as E-Revos or E-Maxx class automobiles)
USB programs capability by means of Castle Link USB adapter (not consisted of,
    order CSEM6300)
Water resistant for usage in almost every environment (not meant for
    operation while immersed in liquid)
Suitable with the Castle Creations 14xx series NeuCastle motors
Reversible with reverse lockout

CONSISTS OF:
Sidewinder SV3 12V ESC with 13 gauge Battery Wires with Pre-Tinned
    Leads, 4mm Female Bullets for Motor Connection, Receiver Connector
    On/Off Change, and Directions

NEEDS:
Battery adapters

SPECS:
Input Voltage: 2S LiPo minimum, THREE LiPo optimum, 9 cell NiCd/NiMH
Brake: Proportional
Reversible: Yes, with lockout
Dimensions: 1.93 x 1.48 x 0.79" (49 x 38 x 20mm)
Weight: 1.96 oz (55.5 g) with 5" (127mm) long battery wires and no
    battery adapter

Right here is a wonderful item that several others have purchased the very same time.

Push Rod Assmbld W/Rod Ends (2) For Use W/#5359 Revo

These are the (optional) Steel Pushrods for the Rocker Arms
for the REVO from Traxxas
These go in between the Rocker Arms and the Lower Suspension Arms

FEATURES:
Black steel construction

CONSISTS OF:
2 Pushrods w/pre-installed rod ends and balls

NEEDS:
Setting up on the vehicle

SPECS:
Length: 5.4" (137mm) end to end including rod ends
Size: 0.20" (5mm)

COMMENTS:
For rod ends only utilize TRAC5347

This item compliments the above discussed item.

Castle Bec 10Amp (25 Volt Max Input)

This is the CC BEC 10A Receiver Battery Remover by Castle Creations.

FEATURES:
Removes the requirement for a receiver and servo battery pack
Draws greater voltage from the motor batteries and drops it to a
    voltage level suitable for the receiver and servos

CONSISTS OF:
One CC BEC receiver battery eliminator

NEEDS:
Installation in the aircraft

SPECS:
Length: 1.2" (30mm)
Width: .6" (15mm)
Height: .4" (10mm)
Weight: .4oz (11g)
Input voltage: 5V to 25.2V (2S to 6S LiPo)
Present output: 12 volts input = 7 amps* constant, 10 amp peak;
    24 volts input = 5 amps* constant, 7 amp peak
    *Ratings are figured out with a 5mph air flow on the BEC
Selectable Output: 4.8 - 9.0V by means of the Castle Link (sold independently)
    Default voltage is 5.1V

This item compliments the above discussed item.

Rock Crawler Brushed Motor 35T HD

This is the Tekin T35 HD 35 Turn Rock Crawler Brushed Motor.

FEATURES:
High-strength updated ferrite magnets
Legal for rock crawling competitors
Totally rebuildable
Dual accuracy ball bearings
120 day limited service warranty

CONSISTS OF:
Tekin T35 HD 35 Turn Rock Crawler Brushed Motor

NEEDS:
ESC such as the Tekin FXR Brushed ESC, TEKM1091
Motor leads
Pinion gear depending on vehicle

SPECS:
Input Voltage: THREE LiPo or 10-cell NiMH battery
Dimensions: 2.07 x 1.42" (52.7 x 36mm)
Shaft Size: 0.125" (3.2mm)
Bearing Size: 3/8 x 1/8"
Motor Weight: 5.98oz (169g)