Castle Creations Sidewinder 3 Waterproof 1:10Th 12V Sport Car Esc

This is the Castle Creations Sidewinder SV3 12V Electronic Speed Control.

FEATURES:
Suggested for all 1/10 scale buggy and truggy applications that
    weigh less than 5lbs (2.25kg) all set to run (not for usage in much heavier
    cars such as E-Revos or E-Maxx class cars)
USB programming ability through Castle Link USB adapter (not consisted of,
    order CSEM6300)
Water resistant for usage in almost every environment (not meant for
    operation while submerged in liquid)
Compatible with the Castle Creations 14xx series NeuCastle motors
Reversible with reverse lockout

CONSISTS OF:
Sidewinder SV3 12V ESC with 13 gauge Battery Wires with Pre-Tinned
    Leads, 4mm Female Bullets for Motor Connection, Receiver Connector
    On/Off Change, and Instructions

REQUIRES:
Battery adapters

SPECS:
Input Voltage: TWO LiPo minimum, 3S LiPo optimum, 9 cell NiCd/NiMH
Brake: Proportional
Reversible: Yes, with lockout
Dimensions: 1.93 x 1.48 x 0.79" (49 x 38 x 20mm)
Weight: 1.96 oz (55.5 g) with 5" (127mm) long battery wires and no
    battery adapter

Below is a terrific item that many others have actually bought at the very same time.

Push Rod Assmbld W/Rod Ends (2) For Use W/#5359 Revo

These are the (optional) Steel Pushrods for the Rocker Arms
for the REVO from Traxxas
These go in between the Rocker Arms and the Lower Suspension Arms

FEATURES:
Black steel building

CONSISTS OF:
Two Pushrods w/pre-installed rod ends and balls

REQUIRES:
Setting up on the vehicle

SPECS:
Length: 5.4" (137mm) end to end consisting of rod ends
Size: 0.20" (5mm)

REMARKS:
For rod ends only utilize TRAC5347

This item praises the above reviewed item.

Castle Bec 10Amp (25 Volt Max Input)

This is the CC BEC 10A Receiver Battery Eliminator by Castle Creations.

FEATURES:
Eliminates the requirement for a receiver and servo battery pack
Draws greater voltage from the motor batteries and drops it to a
    voltage level suitable for the receiver and servos

CONSISTS OF:
One CC BEC receiver battery remover

REQUIRES:
Setup in the airplane

SPECS:
Length: 1.2" (30mm)
Width: .6" (15mm)
Height: .4" (10mm)
Weight: .4oz (11g)
Input voltage: 5V to 25.2V (TWO to SIX LiPo)
Current output: 12 volts input = 7 amps* constant, 10 amp peak;
    24 volts input = 5 amps* constant, 7 amp peak
    *Ratings are determined with a 5mph airflow on the BEC
Selectable Output: 4.8 - 9.0V through the Castle Link (sold separately)
    Default voltage is 5.1V

This item praises the above reviewed item.

Rock Crawler Brushed Motor 35T HD

This is the Tekin T35 HD 35 Turn Rock Spider Brushed Motor.

FEATURES:
High-strength updated ferrite magnets
Legal for rock crawling competitors
Totally rebuildable
Double precision ball bearings
120 day limited warranty

CONSISTS OF:
Tekin T35 HD 35 Turn Rock Spider Brushed Motor

REQUIRES:
ESC such as the Tekin FXR Brushed ESC, TEKM1091
Motor leads
Pinion gear depending upon vehicle

SPECS:
Input Voltage: 3S LiPo or 10-cell NiMH battery
Dimensions: 2.07 x 1.42" (52.7 x 36mm)
Shaft Size: 0.125" (3.2mm)
Bearing Size: 3/8 x 1/8"
Motor Weight: 5.98oz (169g)