Axial Input Shaft 5x29mm (2)

These are the Input Shafts for the Axial Wraith Rock Racer.

FEATURES:
Steel building and construction
Holds bevel gear in place inside transmission

CONSISTS OF:
2 5x29mm Input Shafts

REQUIRES:
Disassembly of transmission to install

This product is regularly bought with the above stated product.

E-Clip E2.5 (10)

This is the 2.5mm E-Clips for the Axial Rock Crawler.

FEATURES:
Metal building and construction, silver in color

CONSISTS OF:
Ten 2.5mm e-clips

REQUIRES:
Installation to the design

The below product likewise pairs truly well with the product being talked about.



These are the optional ST Racing Front and Rear Lower Suspension Hyperlinks
for the Axial SCX10.

FEATURES:
CNC machined aluminum building and construction, silver in color
Fits the Axial SCX10 automobiles with a wheelbase of 12" (305mm)
    including the Deadbolt, Falken Tires JK, and Recon G6 JK

CONSISTS OF:
2 Front Hyperlinks
2 Rear Hyperlinks
Eight M3x16mm Set Screws

REQUIRES:
2 AX80005 Axial Rod Ends, AXIC3805
2 AX80018 Axial Rod End Hyperlinks, AXIC3818

COMMENTS:
(Any unique application or something it will not work with?)

The below product likewise pairs truly well with the product being talked about.

Castle Bec 10Amp (25 Volt Max Input)

This is the CC BEC 10A Receiver Battery Remover by Castle Creations.

FEATURES:
Eliminates the requirement for a receiver and servo battery pack
Draws higher voltage from the motor batteries and drops it to a
    voltage level suitable for the receiver and servos

CONSISTS OF:
One CC BEC receiver battery remover

REQUIRES:
Installation in the airplane

SPECS:
Length: 1.2" (30mm)
Width: .6" (15mm)
Height: .4" (10mm)
Weight: .4oz (11g)
Input voltage: 5V to 25.2V (2S to SIX LiPo)
Present output: 12 volts input = 7 amps* continuous, 10 amp peak;
    24 volts input = 5 amps* continuous, 7 amp peak
    *Ratings are figured out with a 5mph airflow on the BEC
Selectable Output: 4.8 - 9.0V through the Castle Link (sold individually)
    Default voltage is 5.1V

Want one more fantastic product to enhance the above stated product?



This is the replacement Bevel Gear Set for the
Axial AX10 Scorpion Rock Crawler.

FEATURES:
Aluminum building and construction, silver in color
Replaces a worn or damaged bevel gear set

CONSISTS OF:
One 38 Tooth Big Bevel Gear
One 13 Tooth Small Bevel Gear

REQUIRES:
Installation following the design handbook

COMMENTS:
For the heavy-duty version of this gear set order AXIC0395