Axial Body Clip 6mm Black (10)

This is a package of 10 Body Clips from Axial.

FEATURES:
Steel construction, black in color

CONSISTS OF:
10 6mm body clips

SPECIFICATIONS:
Length: .82" (21mm)

You will enjoy this item if you have the item just above discussed.

Landing Skid

Specs:
Landing skid x 1
Washer x 2(Φ2.6xΦ5.8x0.6mm)
Socket button head screw x 2(M2.5x10mm)

Here is a terrific item that several others have purchased the exact same time.

Hexagon Screw Driver

Using on heli's M2 socket screw and M3 socket screw!

Specs:
1.5mm(Black/26.6g)x1
2.0mm(Blue/28.6g)x1
2.5mm(Purple/29.5g)x1
3.0mm(Red/31g)x1

Want an additional terrific item to enhance the above pointed out item?



This is the DuraTrax NiMH 7.2V 5000mAh Onyx Stick Battery Load
with Requirement Connector.

FEATURES:
Suitable sport pack for cars, trucks and boats

CONSISTS OF:
DuraTrax NiMH 7.2V 5000mAh Onyx Stick Battery with Conventional
    Adapter

NEEDS:
NiMH compatible battery charger such as the Duratrax Onyx series

SPECIFICATIONS:
Capacity: 5000mAh
Number of Cells in Series: 6
Ranked Voltage: 7.2V
Minutes. Discharge Voltage: 5.4V
Maximum Recommended Charge Current: 5 amps
Discharge Lead: 14AWG 2.7" (70mm) long wire w/Standard port
Load Measurements: 5.3 x 1.8 x 0.94" (135 x 45 x 24mm)
Weight: 15.6 oz (442 g)
Number of Welds per Connection: 6 spot welds
Cell Size: Sub-C

The below item likewise sets truly well with the item being gone over.



This is the 7.4V 2S 15C 250mAh LiPo Battery from Venom-Group.

FEATURES:
Developed for usage with the Losi micro 1/24 scale rally cars, 4WD
    brief course trucks and little indoor aircraft
Pre-wired with a Molex 51005 port and XH design balance port

CONSISTS OF:
7.4V 2S 15C 250mAh LiPo Battery with Molex 51005 Adapter and XH
    Balance Adapter

NEEDS:
LiPo battery charger with balancing ability

SPECIFICATIONS:
Configuration: 2S1P
Weight: 0.56 oz (16g)
Measurements: 1.3 x 0.51 x 0.83" (33 x 13 x 21mm)
Constant Discharge: 15C (3.75A)
Max Burst Rate: 30C (7.5A)
Watt Hours: 1.85

REMARKS:
CHECK OUT the WHOLE guidelines before usage
ALWAYS use a LiPo-approved battery charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents higher than 1C
NEVER Charge through the "To ESC or "RELEASE" lead
NEVER Trickle Charge
NEVER enable to Discharge below 2.5V per cell
NEVER take apart or modify pack wiring in any method or leak cells
NEVER put on flammable materials or leave unattended during
    Charging
ALWAYS charge in a fireproof place
ALWAYS set battery charger's output volts to match battery volts
ALWAYS stay out of reach of kids

This item compliments the above gone over item.

Spurs 48DP 87T

This is the 48 Pitch 87 Tooth Spur Equipment for the Scorpion Rock Crawler AXIC9001.

FEATURES:
Black plastic construction

CONSISTS OF:
One 48DP 87T spur equipment

NEEDS:
Installation on the Rock Crawler

Many others have acquired this item along with the item that you are presently reading about.

Hex Socket Button Head Black M3x6mm (10)

These are the 3x6mm Hex Socket Button Head Screws utilized on the
Axial Wraith Rock Racer.

FEATURES:
Steel construction, black in color

CONSISTS OF:
10 3x6mm Hex Socket Button Head Screws

NEEDS:
2mm hex wrench, GPMR8011

SPECIFICATIONS:
Length: 6mm
Diameter: 3mm