Axial Body Clip 6mm Black (10)

This is a plan of 10 Body Clips from Axial.

FEATURES:
Steel building and construction, black in color

INCLUDES:
10 6mm body clips

SPECS:
Length: .82" (21mm)

You will certainly enjoy this item if you have the item just above mentioned.

Landing Skid

Requirements:
Landing skid x 1
Washer x 2(Φ2.6xΦ5.8x0.6mm)
Socket button head screw x 2(M2.5x10mm)

Right here is a excellent item that numerous others have purchased the exact same time.

Hexagon Screw Driver

Utilizing on heli's M2 socket screw and M3 socket screw!

Requirements:
1.5mm(Black/26.6g)x1
2.0mm(Blue/28.6g)x1
2.5mm(Purple/29.5g)x1
3.0mm(Red/31g)x1

Want an additional excellent item to compliment the above mentioned item?



This is the DuraTrax NiMH 7.2V 5000mAh Onyx Stick Battery Load
with Standard Connector.

FEATURES:
Ideal sport pack for cars, trucks and boats

INCLUDES:
DuraTrax NiMH 7.2V 5000mAh Onyx Stick Battery with Basic
    Adapter

REQUIRES:
NiMH suitable charger such as the Duratrax Onyx series

SPECS:
Capacity: 5000mAh
Variety of Cells in Series: 6
Rated Voltage: 7.2V
Minutes. Release Voltage: 5.4V
Maximum Recommended Charge Current: 5 amps
Release Lead: 14AWG 2.7" (70mm) long wire w/Standard adapter
Load Measurements: 5.3 x 1.8 x 0.94" (135 x 45 x 24mm)
Weight: 15.6 oz (442 g)
Variety of Welds per Connection: 6 spot welds
Cell Size: Sub-C

The below item likewise sets truly well with the item being gone over.



This is the 7.4V 2S 15C 250mAh LiPo Battery from Venom-Group.

FEATURES:
Created for use with the Losi micro 1/24 scale rally cars, 4WD
    brief course trucks and little indoor airplane
Pre-wired with a Molex 51005 adapter and XH design balance adapter

INCLUDES:
7.4V 2S 15C 250mAh LiPo Battery with Molex 51005 Adapter and XH
    Balance Adapter

REQUIRES:
LiPo charger with balancing capability

SPECS:
Setup: 2S1P
Weight: 0.56 oz (16g)
Measurements: 1.3 x 0.51 x 0.83" (33 x 13 x 21mm)
Continuous Discharge: 15C (3.75A)
Max Burst Rate: 30C (7.5A)
Watt Hours: 1.85

COMMENTS:
READ the ENTIRE directions prior to use
ALWAYS utilize a LiPo-approved charger
ALWAYS utilize a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents greater than 1C
NEVER Charge through the "To ESC or "DISCHARGE" lead
NEVER EVER Trickle Charge
NEVER permit to Release listed below 2.5V per cell
NEVER take apart or customize pack electrical wiring in any way or puncture cells
NEVER put on flammable products or leave ignored throughout
    Charging
ALWAYS charge in a fireproof place
ALWAYS set charger's output volts to match battery volts
CONSTANTLY keep out of reach of children

This item compliments the above gone over item.

Spurs 48DP 87T

This is the 48 Pitch 87 Tooth Spur Gear for the Scorpion Rock Spider AXIC9001.

FEATURES:
Black plastic building and construction

INCLUDES:
One 48DP 87T stimulate gear

REQUIRES:
Setup on the Rock Spider

Many others have purchased this item in addition to the item that you are presently reading about.

Hex Socket Button Head Black M3x6mm (10)

These are the 3x6mm Hex Socket Button Head Screws used on the
Axial Wraith Rock Racer.

FEATURES:
Steel building and construction, black in color

INCLUDES:
10 3x6mm Hex Socket Button Head Screws

REQUIRES:
2mm hex wrench, GPMR8011

SPECS:
Length: 6mm
Diameter: 3mm