ARRMA BLX185 6S ESC

This is the Arrma BLX185 6S 150A Electronic Speed Control.

FEATURES:
Can be powered by 2 3-6S (11.1-22.2V) LiPo batteries, 35C 5000mAh
    minimum requirement
6.0V/3A continuous output, 12A max
Bridge connector for utilizing single 4S or 6S battery
Over voltage and overheat security
2 phase LiPo cutoff, single phase NiMH cutoff
Temperature security mode if ESC temperature level surpasses 221°F
    (105°C)
Integrated cooling fan to minimize heat during extreme running
Waterproof under typical use
Integrated hold down tabs easily safe and secure inside automobile chassis
Establish for usage from factory, settings may be altered

INCLUDES:
BLX185 6S ESC with Cooling Fan, 2 Accumulate XT90 Battery Connectors
    with 10AWG Wires, Receiver Plug, Power Change and Set Button
    10AWG Motor Wires with 4mm Size Gold Plated Female Connectors,
    Directions and Bridge Connector

NEEDS:
Motor such as the Arrma BLX 2050Kv 6S Brushless Motor, ARAG2000

SPECS:
Length: 2.26" (57.5mm)
Width: 2.34" (59.5mm) including hold down tabs
Height: 1.53" (38.9mm)
Weight: 6.9oz (196g)
Change Length: 1.15" (29.3mm)
Change Width: 0.5" (12.8mm)
Change Height: 0.71" (18mm)
Receiver Wire Length: 7.87" (200mm)
Battery Wire Length: 6.5" (165mm)
Motor Wire Length: 5.12" (130mm) including connector
Motor Limitation: 3000kV
Wire Size: 10AWG
Motor Connectors: Gold bullet
Battery Connectors: 2 Accumulate XT90
BEC Voltage: 6.0V
BEC Current Minimum Constant: 3A
BEC Current Max Burst: 12A
Low Voltage Cutoff: 3.2V
Over Voltage Security: Over 6S LiPo (22.2V)
Continouous Amp Rating: 150A
Throttle Mode: FWD/BRAKE/REV
Throttle Setup: Handbook by means of pushbutton
User Programmable: Yes, by means of button just
Battery Mode: LiPo/NiMH, default LiPo mode