ARRMA BLX185 6S ESC

This is the Arrma BLX185 6S 150A Electronic Speed Control.

FEATURES:
Can be powered by two 3-6S (11.1-22.2V) LiPo batteries, 35C 5000mAh
    minimum requirement
6.0V/3A constant output, 12A max
Bridge port for utilizing single 4S or 6S battery
Over voltage and get too hot defense
2 phase LiPo cutoff, single phase NiMH cutoff
Temperature level defense mode if ESC temperature surpasses 221°F
    (105°C)
Integrated cooling fan to reduce heat throughout severe running
Water resistant under regular usage
Integrated hold down tabs easily safe inside automobile chassis
Set up for usage from factory, settings might be changed

CONSISTS OF:
BLX185 6S ESC with Cooling Fan, two Amass XT90 Battery Connectors
    with 10AWG Wires, Receiver Plug, Power Switch and Set Button
    10AWG Motor Wires with 4mm Size Gold Plated Female Connectors,
    Guidelines and Bridge Connector

NEEDS:
Motor such as the Arrma BLX 2050Kv 6S Brushless Motor, ARAG2000

SPECS:
Length: 2.26" (57.5mm)
Width: 2.34" (59.5mm) including hold down tabs
Height: 1.53" (38.9mm)
Weight: 6.9oz (196g)
Switch Length: 1.15" (29.3mm)
Switch Width: 0.5" (12.8mm)
Switch Height: 0.71" (18mm)
Receiver Wire Length: 7.87" (200mm)
Battery Wire Length: 6.5" (165mm)
Motor Wire Length: 5.12" (130mm) including port
Motor Limitation: 3000kV
Wire Size: 10AWG
Motor Connectors: Gold bullet
Battery Connectors: 2 Amass XT90
BEC Voltage: 6.0V
BEC Current Minimum Continuous: 3A
BEC Current Max Burst: 12A
Low Voltage Cutoff: 3.2V
Over Voltage Protection: Over 6S LiPo (22.2V)
Continouous Amp Ranking: 150A
Throttle Mode: FWD/BRAKE/REV
Throttle Setup: Handbook by means of pushbutton
User Programmable: Yes, by means of button just
Battery Mode: LiPo/NiMH, default LiPo mode