ARRMA BLX185 6S ESC

This is the Arrma BLX185 6S 150A Electronic Speed Control.

FEATURES:
Can be powered by 2 3-6S (11.1-22.2V) LiPo batteries, 35C 5000mAh
    minimum requirement
6.0V/3A constant output, 12A max
Bridge port for utilizing single FOUR or SIX battery
Over voltage and overheat defense
Two stage LiPo cutoff, single stage NiMH cutoff
Temperature defense mode if ESC temperature exceeds 221°F
    (105°C)
Integrated cooling fan to minimize heat throughout severe running
Water resistant under normal use
Integrated hold down tabs easily protected inside automobile chassis
Establish for usage from factory, settings may be changed

CONSISTS OF:
BLX185 SIX ESC with Cooling Fan, 2 Accumulate XT90 Battery Connectors
    with 10AWG Wires, Receiver Plug, Power Switch and Set Button
    10AWG Motor Wires with 4mm Size Gold Plated Female Connectors,
    Directions and Bridge Adapter

NEEDS:
Motor such as the Arrma BLX 2050Kv 6S Brushless Motor, ARAG2000

SPECS:
Length: 2.26" (57.5mm)
Width: 2.34" (59.5mm) consisting of hold down tabs
Height: 1.53" (38.9mm)
Weight: 6.9oz (196g)
Switch Length: 1.15" (29.3mm)
Switch Width: 0.5" (12.8mm)
Switch Height: 0.71" (18mm)
Receiver Wire Length: 7.87" (200mm)
Battery Wire Length: 6.5" (165mm)
Motor Wire Length: 5.12" (130mm) consisting of port
Motor Limit: 3000kV
Wire Size: 10AWG
Motor Connectors: Gold bullet
Battery Connectors: Two Accumulate XT90
BEC Voltage: 6.0V
BEC Current Minimum Constant: 3A
BEC Current Max Burst: 12A
Low Voltage Cutoff: 3.2V
Over Voltage Security: Over SIX LiPo (22.2V)
Continouous Amp Rating: 150A
Throttle Mode: FWD/BRAKE/REV
Throttle Setup: Manual via pushbutton
User Programmable: Yes, via button just
Battery Mode: LiPo/NiMH, default LiPo mode