ARRMA BLX185 6S ESC

This is the Arrma BLX185 6S 150A Electronic Speed Control.

FEATURES:
Can be powered by two 3-6S (11.1-22.2V) LiPo batteries, 35C 5000mAh
    minimum requirement
6.0V/3A continuous output, 12A max
Bridge connector for using single 4S or 6S battery
Over voltage and get too hot defense
Two phase LiPo cutoff, single phase NiMH cutoff
Temperature defense mode if ESC temperature surpasses 221°F
    (105°C)
Integrated cooling fan to decrease heat during extreme running
Water resistant under regular usage
Integrated hold down tabs easily safe and secure inside car chassis
Establish for usage from factory, settings might be altered

CONSISTS OF:
BLX185 6S ESC with Cooling Fan, two Generate XT90 Battery Connectors
    with 10AWG Wires, Receiver Plug, Power Change and Set Button
    10AWG Motor Wires with 4mm Size Gold Plated Female Connectors,
    Guidelines and Bridge Port

REQUIRES:
Motor such as the Arrma BLX 2050Kv 6S Brushless Motor, ARAG2000

SPECIFICATIONS:
Length: 2.26" (57.5mm)
Width: 2.34" (59.5mm) consisting of hold down tabs
Height: 1.53" (38.9mm)
Weight: 6.9oz (196g)
Change Length: 1.15" (29.3mm)
Change Width: 0.5" (12.8mm)
Change Height: 0.71" (18mm)
Receiver Wire Length: 7.87" (200mm)
Battery Wire Length: 6.5" (165mm)
Motor Wire Length: 5.12" (130mm) consisting of connector
Motor Limit: 3000kV
Wire Size: 10AWG
Motor Connectors: Gold bullet
Battery Connectors: Two Generate XT90
BEC Voltage: 6.0V
BEC Current Minimum Continuous: 3A
BEC Current Max Burst: 12A
Low Voltage Cutoff: 3.2V
Over Voltage Defense: Over 6S LiPo (22.2V)
Continouous Amp Ranking: 150A
Throttle Mode: FWD/BRAKE/REV
Throttle Setup: Handbook by means of pushbutton
User Programmable: Yes, by means of button just
Battery Mode: LiPo/NiMH, default LiPo mode