ARRMA BLX185 6S ESC

This is the Arrma BLX185 6S 150A Electronic Speed Control.

FEATURES:
Can be powered by two 3-6S (11.1-22.2V) LiPo batteries, 35C 5000mAh
    minimum requirement
6.0V/3A constant output, 12A max
Bridge connector for utilizing single 4S or 6S battery
Over voltage and overheat security
2 stage LiPo cutoff, single stage NiMH cutoff
Temperature security mode if ESC temperature surpasses 221°F
    (105°C)
Integrated cooling fan to minimize heat throughout extreme running
Waterproof under typical use
Integrated hold down tabs quickly secure inside vehicle chassis
Establish for usage from factory, settings may be changed

CONSISTS OF:
BLX185 6S ESC with Cooling Fan, two Accumulate XT90 Battery Connectors
    with 10AWG Wires, Receiver Plug, Power Change and Set Button
    10AWG Motor Wires with 4mm Diameter Gold Plated Female Connectors,
    Directions and Bridge Connector

REQUIRES:
Motor such as the Arrma BLX 2050Kv 6S Brushless Motor, ARAG2000

SPECS:
Length: 2.26" (57.5mm)
Width: 2.34" (59.5mm) including hold down tabs
Height: 1.53" (38.9mm)
Weight: 6.9oz (196g)
Change Length: 1.15" (29.3mm)
Change Width: 0.5" (12.8mm)
Change Height: 0.71" (18mm)
Receiver Wire Length: 7.87" (200mm)
Battery Wire Length: 6.5" (165mm)
Motor Wire Length: 5.12" (130mm) including connector
Motor Limit: 3000kV
Wire Size: 10AWG
Motor Connectors: Gold bullet
Battery Connectors: 2 Accumulate XT90
BEC Voltage: 6.0V
BEC Current Minimum Constant: 3A
BEC Current Max Burst: 12A
Low Voltage Cutoff: 3.2V
Over Voltage Security: Over 6S LiPo (22.2V)
Continouous Amp Rating: 150A
Throttle Mode: FWD/BRAKE/REV
Throttle Setup: Handbook by means of pushbutton
User Programmable: Yes, by means of button just
Battery Mode: LiPo/NiMH, default LiPo mode