Align T-REX 600E PRO DFC Combo (No 3GX)

Requirements(T-REX 600E PRO DFC) :
1.Equipped with the low CG DFC rotor head, effectively reduce wind resistance throughout flight, offering the most direct and precise control feel back to the pilot, and displays exhilarating 3D performance and unimaginable flight speed.
2.The frame makes use of 2mm carbon fiber plates of the highest specification. Trademarked composite material building and construction technique skillfully make use of frame area that improved overall rigidness, and also produced a minimalistic charm.
3.Ingenious moving battery tray rails anchored into the 3K side frames, with patented spring loaded locking system, permitting quick battery gain access to in addition to battery security.
4.Heatsink embedded into motor install for effective cooling of motor.
5.Top mounted motor base bringing the motor?s center of mass better to turning disc, improving 3D dexterity.
6.Utilize direct link CCPM swashplate control system to make it possible for direct and quick control reaction. Specifically designed anodized CNC servo horns are not just visually pleasing, however are extremely stiff.
7.Uses highest spec CNC modue-1 helical primary equipment, with highest load tolerance and least expensive noise.
8.The most optimum motor pinion ratio and tail equipment ratio to accomplish the most effective power output and flight particular.
9.High quality 5mm carbon rod and CNC metal tail scissor control arms are used in rudder control system to enhance rudder lockingand control effectiveness.
10.Additional radial bearing is contributed to the one way bearing block to make sure smooth rotation, and get rid of jammed one way bearing.
11.Brand new 600 class 12S high voltage brushless motor offering generous torque and power output, yet consumes lower typical current to lengthen the life of batteries
12.Motor install includes 3rd bearing block to supply motor shaft assistance, effectively reduce torque caused shifts, and minimize equipment striping concern.
13.High quality new tail transmission style, combined with new dual point mounted tail pitch control assembly to minimize slops and increase rudder control accuracy.
14.Brand new CNC machined metal tail gear box, with thicker side plates to increase rigidness. The more structured style also enables easier disassembly.
15.Overall pitch series of +15~-15 degrees, for the supreme 3D explosive power.
16.Tail pitch system geared up with high accuracy bearing.
17.High speed thrust bearings in tail blade grips.
18.New lightened landing equipment assembly with lower center of mass.
19.High quality painted fiberglass canopy with 4-point quick release mounts.

Users need to have a certain principle of security to run the R/C helicopters.
Be sure to read and abide by related safety notes of user's manual prior to flying.

Requirements(T-REX 600E PRO DFC):
Length: 1174mm
Height: 319mm
Width: 210mm
Main Blade Length: 600mm
Main Rotor Size: 1347mm
Tail Rotor Size: 260mm
Motor Drive Equipment:13T
Main Drive Equipment:112T
Autorotation Tail Own Equipment: 131T
Tail Own Equipment: 34T
Own Equipment Ratio: 1:8.61:3.85
Weight(With Motor): 2290g

Devices:
T-REX 600E PRO DFC Packages Set X1
600 3G Carbon fiber blades X1
600MX Brushless Motor(510KV) X1
DS615 Requirement servo X3
DS655 Specialized servo X1
Castle ICE2 HV 80 Brushless ESC X1
6A External BEC w/ 5.1V Two-way Step-down voltage regulator X1

Radio transmitter and electronic devices needed for assembly:
Transmitter(7-channel or more, helicopter system)
Receiver(7-channel or more)
6S Li-Po 2600 ~ 4600mAh X2 (3300mAh recommendation)
Dial Pitch Gauge or Digital Pitch Gauge
3GX Flybarless System X1