Align T-REX 600E PRO DFC Combo (No 3GX)

Requirements(T-REX 600E PRO DFC) :
1.Equipped with the low CG DFC rotor head, efficiently reduce wind resistance during flight, supplying the most direct and exact control feel back to the pilot, and displays thrilling 3D performance and unimaginable flight speed.
2.The frame utilizes 2mm carbon fiber plates of the greatest specification. Trademarked composite product building and construction strategy cleverly use frame space that enhanced overall rigidness, and also produced a minimalistic appeal.
3.Ingenious moving battery tray rails imbedded into the 3K side frames, with trademarked spring packed latching mechanism, permitting fast battery access in addition to battery defense.
4.Heatsink ingrained into motor install for efficient cooling of motor.
5.Top installed motor base bringing the motor?s center of gravity better to turning disc, enhancing 3D dexterity.
6.Utilize direct link CCPM swashplate control system to make it possible for direct and quick control reaction. Specifically developed anodized CNC servo horns are not only visually pleasing, but are extremely rigid.
7.Uses greatest spec CNC modue-1 helical primary equipment, with greatest load tolerance and lowest noise.
8.The most ideal motor pinion ratio and tail equipment ratio to accomplish the most efficient power output and flight particular.
9.High quality 5mm carbon rod and CNC metal tail scissor control arms are utilized in rudder control system to improve rudder lockingand control efficiency.
10.Extra radial bearing is added to the one method bearing block to guarantee smooth rotation, and get rid of jammed one method bearing.
11.Brand brand-new 600 class 12S high voltage brushless motor supplying generous torque and power output, yet consumes lower typical current to extend the life of batteries
12.Motor install includes third bearing block to provide motor shaft support, efficiently reduce torque induced shifts, and decrease equipment striping concern.
13.High quality brand-new tail gearbox design, combined with brand-new dual point installed tail pitch control assembly to decrease slops and increase rudder control precision.
14.Brand brand-new CNC machined metal tail gear box, with thicker side plates to increase rigidness. The more structured design also permits easier disassembly.
15.Total pitch variety of +15~-15 degrees, for the ultimate 3D explosive power.
16.Tail pitch mechanism equipped with high precision bearing.
17.High speed thrust bearings in tail blade grips.
18.New lightened landing equipment assembly with lower center of gravity.
19.High quality painted fiberglass canopy with 4-point fast release mounts.

Users must have a certain principle of security to operate the R/C helicopters.
Be sure to check out and abide by related security notes of user's manual before flying.

Requirements(T-REX 600E PRO DFC):
Length: 1174mm
Height: 319mm
Width: 210mm
Main Blade Length: 600mm
Main Rotor Diameter: 1347mm
Tail Rotor Diameter: 260mm
Motor Drive Equipment:13T
Main Drive Equipment:112T
Autorotation Tail Own Equipment: 131T
Tail Own Equipment: 34T
Own Equipment Ratio: 1:8.61:3.85
Weight(With Motor): 2290g

Devices:
T-REX 600E PRO DFC Packages Set X1
600 3G Carbon fiber blades X1
600MX Brushless Motor(510KV) X1
DS615 Requirement servo X3
DS655 Specialized servo X1
Castle ICE2 HV 80 Brushless ESC X1
6A External BEC w/ 5.1V Two-way Step-down voltage regulator X1

Radio transmitter and electronic equipment required for assembly:
Transmitter(7-channel or more, helicopter system)
Receiver(7-channel or more)
6S Li-Po 2600 ~ 4600mAh X2 (3300mAh idea)
Dial Pitch Gauge or Digital Pitch Gauge
3GX Flybarless System X1