Align T-Rex 500 PRO DFC Combo Helicopter Kit (No 3GX)

This is the Align T-REX 500 PRO DFC Flybarless Super Combination Helicopter Set 3GX Not Consisted of. This extraordinary bundle includes not just the T-REX 500 PRO DFC Set, however likewise a 425 3G Carbon Fiber blade set, 3 DS515M digital cyclic servos, one DS525M digital tail servo, the RCE-BL70G Brushless Electronic Speed Control and the powerful 500MX, 1600kV Brushless motor. This incredibly combo provides you with an unbelievable helicopter kit and a similarly impressive electronic bundle all in one box. Just include the 3GX Progammable Flybarless System (AGNHEG3GX01) to this helicopter bundle for fantastic flight efficiency.
T-REX 500 PRO Includes: The Align 500 PRO DFC helicopter is equipped with an extremely low CG design to successfully reduce wind resistance throughout flight and provide the most direct and exact control feel back to the pilot, providing exhilarating 3D efficiency and unthinkable flight speed.
A uniquely carbon composite technology successfully reinforce the weak locations and provides streamlined electronics setup.
The servos can be installed straight onto the frame without installing nuts.
The rear servo is installed in-frame for a centralized design and optimum 3D efficiency.
MX series high efficiency brushless motor consisted of with heatsink design housing and embedded fan to drastically improve cooling and increase power output.
Unique quick release gyro and receiver mount design for quick removal and durable accessory.
High precision slant tooth (helical) main gear for higher load sustainability and lower noise output.
Redesigned tail transmission with higher material quality and easy upkeep.
High quality tail gearbox design, integrated with upgraded double point installed tail pitch control assembly to lessen slop and increase rudder control precision.
Highly efficient shaft owned tail system which successfully reduce power loss found on belt owned systems. This likewise increases efficiency throughout flight.
Redesigned 4mm carbon rudder control rod and metal rudder pitch bell crank to more improve the rudder locking result and controllability.
Redesigned design battery installing platform to reinforce the frame as well as to provide an install for the electronic speed controller.
Redesigned lower CG landing gear design.
Styled aerodynamically canopy for the ultimate fit, making the helicopter stand out.
Best tail gear ratio to lessen vibrations brought on by the high speed operations of the main blades, bringing the best tail locking power.

T-REX 500 PRO Specifications:

Length: 868mm

Height: 275mm

Main Blade Length: 425mm

Main Rotor Size: 978mm

Tail Rotor Size: 206mm

Motor Drive Equipment: 12T

Main Drive Equipment: 134T

Autorotation Tail Drive Equipment: 145T

Tail Drive Equipment: 36T

Drive Equipment Ratio: 1:11.17:4.03

Weight (With Motor): 1210g

Includes: (1) T-REX 500 PRO DFC Set
(1) 425 3G Carbon Fiber blades


(1) 500MX Brushless Motor (1600kV)
(3) DS515M Digital servo


(1) DS525M Digital servo


(1) RCE-BL70G Brushless ESC 

Needed to Total:


Transmitter (7-channel or more, helicopter system)
Receiver (7-channel or more)
(2) 6S LiPo Battery Pack 2600 ~ 4600mAh (3300mAh suggested)
Digital Pitch Gauge
3GX Flybarless System