Align T-Rex 500 PRO DFC Combo Helicopter Kit (No 3GX)

This is the Align T-REX 500 PRO DFC Flybarless Super Combo Helicopter Package 3GX Not Included. This extraordinary package consists of not just the T-REX 500 PRO DFC Package, however also a 425 3G Carbon Fiber blade set, three DS515M digital cyclic servos, one DS525M digital tail servo, the RCE-BL70G Brushless Electronic Speed Control and the effective 500MX, 1600kV Brushless motor. This super combination provides you with an amazing helicopter kit and an equally remarkable electronic package all in one box. Just include the 3GX Progammable Flybarless System (AGNHEG3GX01) to this helicopter package for fantastic flight efficiency.
T-REX 500 PRO Includes: The Align 500 PRO DFC helicopter is geared up with a very low CG design to successfully minimize wind resistance throughout flight and offer the most direct and accurate control feel back to the pilot, offering thrilling 3D efficiency and inconceivable flight speed.
A uniquely carbon composite innovation successfully reinforce the weak areas and provides simplified electronic devices setup.
The servos can be installed straight onto the frame without installing nuts.
The rear servo is installed in-frame for a centralized design and optimum 3D efficiency.
MX series high effectiveness brushless motor consisted of with heatsink design housing and ingrained fan to drastically enhance cooling and increase power output.
Distinct fast release gyro and receiver mount design for fast removal and sturdy attachment.
High accuracy slant tooth (helical) main equipment for greater load sustainability and lower sound output.
Upgraded tail transmission with greater material quality and easy maintenance.
High quality tail gearbox design, combined with upgraded dual point installed tail pitch control assembly to decrease slop and increase rudder control accuracy.
Highly effective shaft owned tail system which successfully minimize power loss found on belt owned systems. This also increases efficiency throughout flight.
Upgraded 4mm carbon rudder control rod and metal rudder pitch bell crank to more enhance the rudder locking impact and controllability.
Upgraded design battery installing platform to reinforce the frame in addition to to offer an install for the electronic speed controller.
Upgraded lower CG landing equipment design.
Styled aerodynamically canopy for the supreme fit, making the helicopter stand apart.
Best tail equipment ratio to decrease vibrations brought on by the high speed operations of the main blades, bringing the best tail locking power.

T-REX 500 PRO Specifications:

Length: 868mm

Height: 275mm

Main Blade Length: 425mm

Main Rotor Size: 978mm

Tail Rotor Size: 206mm

Motor Drive Equipment: 12T

Main Drive Equipment: 134T

Autorotation Tail Drive Equipment: 145T

Tail Drive Equipment: 36T

Drive Equipment Ratio: 1:11.17:4.03

Weight (With Motor): 1210g

Consists of: (1) T-REX 500 PRO DFC Package
(1) 425 3G Carbon Fiber blades


(1) 500MX Brushless Motor (1600kV)
(3) DS515M Digital servo


(1) DS525M Digital servo


(1) RCE-BL70G Brushless ESC 

Needed to Total:


Transmitter (7-channel or more, helicopter system)
Receiver (7-channel or more)
(2) SIX LiPo Battery Pack 2600 ~ 4600mAh (3300mAh suggested)
Digital Pitch Gauge
3GX Flybarless System