Align T-Rex 150 DFC Combo BTF Twin BL Motor, 2S 7.4V 250Mah

Align's tiniest and most small 3D helicopter T-Rex 150 DFC, carries the same remarkable pedigree and design idea that stemmed from the successful T-Rex line of helicopters. Featuring strong power, remarkable flight control stability, and geared up with high end elements, far going beyond any other helicopters currently on the market.

Twin brushless motor design, paired with 2s 7.4v 250mah battery, producing power that will go beyond all your expectations. Metal DFC primary rotor head assembly including high end aesthetic and remarkable flight performance; in addition, an integrated control system with specifically optimized 3-axis gyro, receiver, electronic speed controller, and 4g servos. All of these enable the T-Rex 150 DFC to posses the same stability, remarkable agility, and tail holding effectiveness as the bigger helicopters.

T-Rex 150 features built in Futaba S-FHSS 2.4Ghz system, and support using Spektrum DSM2/DSMX / JR DSM2/DSMJ/DMSS satellite receivers. To get the T-Rex 150 airborne, all thats needed is inputting of parameters listed in manual into your transmitter, and binding of your transmitter.

Miniature size, control accuracy that resembles the bigger helicopters, allows you to take pleasure in flying inside a confined space. Newbies can even enjoy this with ease by just turning down the speed dial. The ingenious breakthrough T-Rex 150 will bring you a new measurement of flying enjoyment.

Specification:
Length: 255mm
Height: 80mm
Main Blade Length: 120mm
Main Rotor Size: 271mm
Tail Rotor Size: 41mm
Motor Pinion Gear: 10T
Main Drive Gear: 78T
Drive Gear Ratio: 1:7.8
Weight (w/o Battery): 53g

Devices:
T-REX 150 DFC Set x 1
Main Blades x 2set
Tail Blades x 1
150M Main Motor x 1
150M Tail Motor x 1
S150 micro Servo x 2
DS155 micro Servo x 1
Blnd Plug x 1
Remote Extension x 1
7.5V Li-Po 250mAh Li-Polymer Battery x 1

Radio transmitter and electronic equipment needed for assembly:
1.ALIGN T6 or Futaba S-FHSS 2.4G Transmitter or JR DSM2/DSMJ/DMSS、Spektrum DSM2/DSMX 2.4GHz Transmitter

Want one more wonderful item to compliment the above mentioned item?

2S1P 7.4V 250mAh/30C

Usage for T-REX 150.

Guideline::
Max Constant Discharge: 30C. Regular operating temperature is approx. 40-65?C(within 80% of rated discharge). Max. temperature: 80?C.
Recommend to release the battery within 80% of rated discharge, keep 95% capacity when over 100 cycles, keep 90% capacity when over 150 cycles.(The cycle life and performance will reduce due to high existing, high temperature and over-discharge)

KEEP IN MIND::
When using high energy Li-poly Battery, please do not over-discharge, over-charge batteries, or result over-high temperature. Releasing capacity cannot go beyond 80% of the max capacity after full crediting make sure an excellent cycle performance.Recommend to full charge a brand new battery prior to using and just release the battery 50% for first 5 times to make an excellent performance of the battery. Please make it a practice to always count time for flight, or please set a low voltage defense on ESC (Cell voltage after stopping using can not reduce than 3.4V). Do not utilize the battery at inadequate of voltage.

Do not expose batteries to sunlight or store/ charge batteries at the temperature as much as 35℃ in a airtight vehicle. The environment high temperature could cause the damage or the danger of burst. If the battery ends up being hot while high existing discharging or flying, please do not charge the battery right away. Wait to cool down(about 20 mins), then check to recharge. If versus follow the initial factory using rules, possibly cause the battery to pump up or any hazardous accident occurs.
Do not leave the charger is operating unattended as it might cause a fire.

Specifications:
Output:7.4V250mAh (2S1P)
Measurement:47x21.5x12mm
Weight:15g