Align T-Rex 150 DFC Combo BTF Twin BL Motor, 2S 7.4V 250Mah

Align's tiniest and most petite 3D helicopter T-Rex 150 DFC, carries the very same superior pedigree and design principle that stemmed from the successful T-Rex line of helicopters. Featuring strong power, superior flight control stability, and geared up with luxury parts, far surpassing other helicopters currently on the market.

Twin brushless motor design, paired with 2s 7.4v 250mah battery, developing power that will go beyond all your expectations. Metal DFC primary rotor head assembly including luxury aesthetic and superior flight performance; in addition, an integrated control system with specifically enhanced 3-axis gyro, receiver, electronic speed controller, and 4g servos. All of these allow the T-Rex 150 DFC to posses the very same stability, superior dexterity, and tail holding efficiency as the bigger helicopters.

T-Rex 150 features built in Futaba S-FHSS 2.4Ghz system, and support the use of Spektrum DSM2/DSMX / JR DSM2/DSMJ/DMSS satellite receivers. To get the T-Rex 150 airborne, all thats needed is inputting of criteria listed in handbook into your transmitter, and binding of your transmitter.

Miniature size, control precision that resembles the bigger helicopters, allows you to enjoy flying inside a confined space. Beginners can even enjoy this with ease by just rejecting the speed dial. The innovative development T-Rex 150 will bring you a brand-new dimension of flying enjoyment.

Specification:
Length: 255mm
Height: 80mm
Main Blade Length: 120mm
Main Rotor Size: 271mm
Tail Rotor Size: 41mm
Motor Pinion Gear: 10T
Main Drive Gear: 78T
Drive Gear Ratio: 1:7.8
Weight (w/o Battery): 53g

Devices:
T-REX 150 DFC Set x 1
Main Blades x 2set
Tail Blades x 1
150M Main Motor x 1
150M Tail Motor x 1
S150 micro Servo x 2
DS155 micro Servo x 1
Blnd Plug x 1
Remote Extension x 1
7.5V Li-Po 250mAh Li-Polymer Battery x 1

Radio transmitter and electronic equipment required for assembly:
1.ALIGN T6 or Futaba S-FHSS 2.4G Transmitter or JR DSM2/DSMJ/DMSS、Spektrum DSM2/DSMX 2.4GHz Transmitter

Want another fantastic product to compliment the above pointed out product?

2S1P 7.4V 250mAh/30C

Use for T-REX 150.

Guideline::
Max Constant Discharge: 30C. Normal operating temperature level is approx. 40-65?C(within 80% of rated discharge). Max. temperature level: 80?C.
Recommend to discharge the battery within 80% of rated discharge, keep 95% capacity when over 100 cycles, keep 90% capacity when over 150 cycles.(The cycle life and performance will minimize due to high present, high temperature level and over-discharge)

NOTE::
When using high energy Li-poly Battery, please do not over-discharge, over-charge batteries, or result over-high temperature level. Discharging capacity can't surpass 80% of limit capacity after full charging to make sure a good cycle performance.Recommend to full charge a brand brand-new battery prior to using and just discharge the battery 50% for very first 5 times to make a good performance of the battery. Please make it a practice to constantly count time for flight, or please set a low voltage security on ESC (Cell voltage after stopping using can not reduce than 3.4V). Do not use the battery at inadequate of voltage.

Do not expose batteries to sunshine or shop/ charge batteries at the temperature level up to 35℃ in a airtight vehicle. The environment high temperature level might cause the damage or the threat of burst. If the battery becomes hot while high present discharging or flying, please do not charge the battery right away. Wait to cool down(about 20 mins), then inspect to recharge. If versus follow the original factory using guidelines, potentially cause the battery to pump up or any hazardous mishap happens.
Do not leave the charger is running ignored as it may cause a fire.

Specifications:
Output:7.4V250mAh (2S1P)
Measurement:47x21.5x12mm
Weight:15g