Align T-Rex 150 DFC Combo BTF Twin BL Motor, 2S 7.4V 250Mah

Align's tiniest and most small 3D helicopter T-Rex 150 DFC, brings the same remarkable pedigree and design principle that originated from the successful T-Rex line of helicopters. Including strong power, remarkable flight control stability, and equipped with high end components, far exceeding any other helicopters presently on the market.

Twin brushless motor design, paired with 2s 7.4v 250mah battery, creating power that will exceed all your expectations. Metal DFC main rotor head assembly featuring high end aesthetic and remarkable flight performance; in addition, an integrated control system with specifically enhanced 3-axis gyro, receiver, electronic speed controller, and 4g servos. All of these enable the T-Rex 150 DFC to posses the same stability, remarkable dexterity, and tail holding effectiveness as the bigger helicopters.

T-Rex 150 features integrated in Futaba S-FHSS 2.4Ghz system, and support the use of Spektrum DSM2/DSMX / JR DSM2/DSMJ/DMSS satellite receivers. To get the T-Rex 150 airborne, all thats needed is inputting of criteria listed in manual into your transmitter, and binding of your transmitter.

Miniature size, control accuracy that resembles the bigger helicopters, enables you to enjoy flying inside a confined area. Newbies can even enjoy this with ease by simply refusing the speed dial. The ingenious breakthrough T-Rex 150 will bring you a new measurement of flying enjoyment.

Specification:
Length: 255mm
Height: 80mm
Main Blade Length: 120mm
Main Rotor Diameter: 271mm
Tail Rotor Diameter: 41mm
Motor Pinion Gear: 10T
Main Drive Gear: 78T
Drive Gear Ratio: 1:7.8
Weight (w/o Battery): 53g

Accessories:
T-REX 150 DFC Set x 1
Main Blades x 2set
Tail Blades x 1
150M Main Motor x 1
150M Tail Motor x 1
S150 micro Servo x 2
DS155 micro Servo x 1
Blnd Plug x 1
Remote Extension x 1
7.5V Li-Po 250mAh Li-Polymer Battery x 1

Radio transmitter and electronic devices needed for assembly:
1.ALIGN T6 or Futaba S-FHSS 2.4G Transmitter or JR DSM2/DSMJ/DMSS、Spektrum DSM2/DSMX 2.4GHz Transmitter

Want another terrific product to enhance the above stated product?

2S1P 7.4V 250mAh/30C

Use for T-REX 150.

Direction::
Max Constant Discharge: 30C. Typical operating temperature level is approx. 40-65?C(within 80% of ranked discharge). Max. temperature level: 80?C.
Recommend to release the battery within 80% of ranked discharge, keep 95% capability when over 100 cycles, keep 90% capability when over 150 cycles.(The cycle life and performance will minimize due to high present, high temperature level and over-discharge)

NOTE::
When using high energy Li-poly Battery, please do not over-discharge, over-charge batteries, or result over-high temperature level. Discharging capability can't exceed 80% of the max capability after complete charging to ensure a great cycle performance.Recommend to complete charge a brand brand-new battery before using and only release the battery 50% for very first 5 times to make a great performance of the battery. Please make it a practice to constantly count time for flight, or please set a low voltage protection on ESC (Cell voltage after stopping using can not lower than 3.4V). Do not utilize the battery at inadequate of voltage.

Do not expose batteries to sunshine or shop/ charge batteries at the temperature level approximately 35℃ in a airtight car. The environment high temperature level might trigger the damage or the danger of burst. If the battery ends up being hot while high present discharging or flying, please do not charge the battery right away. Wait to cool off(about 20 mins), then check to recharge. If against follow the original factory using rules, possibly trigger the battery to inflate or any dangerous mishap takes place.
Do not leave the battery charger is operating unattended as it may trigger a fire.

Specifications:
Output:7.4V250mAh (2S1P)
Measurement:47x21.5x12mm
Weight:15g