Align 6S1P Li-Poly Battery 40C (22.2V/1100mAh)

This is a Align 6S1P Li-Polymer Battery, and is intended for usage with the Align T-Rex 450 line of helicopters.

Features:

This Li-poly battery is using series/balancing design. It includes high efficient and high discharge, and a inspection device is utilized to match packs.


Suitable for T-Rex 450 series (450MX Brushless Motor 1700KV).
It is advise to discharge the battery within 80% of ranked discharge, keep 90% capacity when over 100 cycles, keep 85% capacity when over 150 cycles.(The cycle life and efficiency will minimize due to high existing, high temperature and over-discharge)

Requirements:

Max Continuous Discharge: 40C

Burst Discharge: 60C

Small Operating Temperature level: Approximate. 40-64?C (104-147?F) (within 80% of ranked discharge)

Maximum Temperature level: 80?C (176?F)

Output: 22.2V(6S1P)1100mAh 102Wh

Dimension: 34x108x25.5mm

Weight: 195g

Keep in mind: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will lead to over heated batteries. Discharging capacity can't exceed 80% of limit capacity of the pack after full charging to make sure a great cycle efficiency. It is advised to fully charge a brand name brand-new battery before using and only discharge the battery 50% for first 5 cycles. Constantly keep an eye on race time and/or set a low voltage caution on ESC (End voltage cannot be lower than 3.2v per cell). Do not utilize the battery that has too low a voltage.



Do not expose batteries to sunshine or store/charge batteries at the temperature above 35?C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high existing discharging or racing, do not charge the battery until it has cooled totally. Wait about 20 mins, then check prior to charging.