Align 470L Feathering Shaft

Use for T-REX 470L

470 Feathering Shaft x 2
Washer(F2.5xF7x1.2mm) x 4
Socket Screw(M2.5x6mm) x 4

Often bought with the thing that you are presently reviewing.

Servo line Color Black & Green

Seeking to tidy up the look of your helicopter, plane of RC vehicle & secure your servo lines from chaffing? Servo Line Covering is an easy way to secure your servo wires, including a tidy, visual want to your RC device, and can be installed in a matter of minutes. Pick from our interesting line of diverse colors to add an entire new look to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the very same with the end of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Also, make certain to take note of the servo wire polarity if you cover the complete wire – this will make sure that you will know what direction to plug your servo terminal into your receiver.