Align 470L Feathering Shaft

Usage for T-REX 470L

470 Feathering Shaft x 2
Washer(F2.5xF7x1.2mm) x 4
Socket Screw(M2.5x6mm) x 4

Frequently purchased with the item that you are currently checking out.

Servo line Color Black & Green

Aiming to clean up the look of your helicopter, plane of RC car & safeguard your servo lines from chaffing? Servo Line Covering is an easy way to safeguard your servo wires, adding a clean, visual look to your RC device, and can be set up in a matter of minutes. Select from our amazing line of varied colors to include a whole make over to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, therefore providing you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, taking care to leave the terminal bare so it can quickly plug into your receiver. Also, be sure to keep in mind of the servo wire polarity if you cover the full wire – this will guarantee that you will know exactly what direction to plug your servo terminal into your receiver.