Align 470L Counter Thread Main Linkage Rod Set

Use for T-REX 470L

470 Linkage Rod x 5
Ball Link x 10

The listed below item likewise pairs truly well with the item being talked about.

Servo line Color Black & Green

Planning to tidy up the look of your helicopter, aircraft of RC cars and truck & secure your servo lines from chaffing? Servo Line Covering is an easy way to secure your servo wires, including a tidy, aesthetic seek to your RC machine, and can be set up in a matter of minutes. Select from our amazing line of varied colors to include a whole makeover to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply remove your servo(s) from the receiver, measure the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, hence giving you a flush, tight fit over the formerly torn servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can quickly plug into your receiver. Also, be sure to remember of the servo wire polarity if you cover the full wire – this will guarantee that you will understand what instructions to plug your servo terminal into your receiver.