Align 470L Counter Thread Main Linkage Rod Set

Usage for T-REX 470L

470 Linkage Rod x 5
Ball Link x 10

The listed below thing also pairs truly well with the thing being gone over.

Servo line Color Black & Green

Planning to clean up the appearance of your helicopter, airplane of RC automobile & safeguard your servo lines from chaffing? Servo Line Covering is an easy way to safeguard your servo wires, adding a tidy, aesthetic planning to your RC maker, and can be installed in a matter of minutes. Pick from our exciting line of different colors to add an entire makeover to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, therefore giving you a flush, tight fit over the previously frayed servo covering. Do the very same with completion of your servo wire, taking care to leave the terminal bare so it can easily plug into your receiver. Likewise, make certain to keep in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will know what direction to plug your servo terminal into your receiver.