Align 470L Counter Thread Main Linkage Rod Set

Usage for T-REX 470L

470 Linkage Rod x 5
Ball Link x 10

The below product also pairs truly well with the product being gone over.

Servo line Color Black & Green

Aiming to tidy up the appearance of your helicopter, plane of RC cars and truck & secure your servo lines from chaffing? Servo Line Covering is an easy way to secure your servo wires, adding a tidy, visual seek to your RC maker, and can be set up in a matter of minutes. Pick from our exciting line of diverse colors to include a whole new look to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, therefore offering you a flush, tight fit over the previously frayed servo covering. Do the very same with the end of your servo wire, taking care to leave the terminal bare so it can easily plug into your receiver. Also, make certain to take note of the servo wire polarity if you cover the full wire – this will make sure that you will know exactly what direction to plug your servo terminal into your receiver.