Align 470L Counter Thread Main Linkage Rod Set

Use for T-REX 470L

470 Linkage Rod x 5
Ball Link x 10

The below item additionally sets really well with the item being talked about.

Servo line Color Black & Green

Looking to clean up the look of your helicopter, airplane of RC cars and truck & secure your servo lines from chaffing? Servo Line Covering is a simple way to secure your servo wires, adding a clean, visual aim to your RC device, and can be set up in a matter of minutes. Pick from our exciting line of diverse colors to add a whole makeover to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, thus providing you a flush, tight fit over the formerly torn servo covering. Do the same with completion of your servo wire, bewaring to leave the terminal bare so it can quickly plug into your receiver. Also, be sure to keep in mind of the servo wire polarity if you cover the full wire – this will ensure that you will understand what instructions to plug your servo terminal into your receiver.