Align 3S1P Li-Poly Battery 30C (11.1V/2200mAh)

This is a Align 3S1P Li-Polymer Battery, and is intended for usage with the Align T-Rex 450 line of helicopters.

Features:

This Li-poly battery is using series/balancing style. It includes high effective and high discharge, and a inspection maker is utilized to match packs.


Appropriate for T-Rex 450 series


Advise to release the battery within 80% of rated discharge, keep 90% capability when over 100 cycles, keep 85% capability when over 150 cycles.(The cycle life and effectiveness will decrease due to high present, high temperature level and over-discharge)

Specs:

Max Constant Discharge: 30C

Burst Discharge: 40C

Small Operating Temperature level: Approx. 40-64?C (104-147?F) (within 80% of rated discharge)

Optimum Temperature level: 80?C (176?F)

Output: 11.1V(3S1P)2200mAh 

Dimension: 36x104x22mm

Weight: 165g

Keep in mind: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capability cannot exceed 80% of limit capability of the pack after full crediting guarantee a good cycle efficiency. It is advised to fully charge a brand name new battery before using and just release the battery 50% for very first 5 cycles. Constantly monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not utilize the battery that has too low a voltage.



Do not expose batteries to sunlight or store/charge batteries at the temperature level above 35?C or in a closed automobile. The high temperature level environment could cause damage to the pack or make it burst. If the battery ends up being hot while fast charging, high present discharging or racing, do not charge the battery until it has cooled entirely. Wait about 20 minutes, then inspect prior to charging.